Used Industrial Boilers for Sale in Florida
Used Industrial Boilers for Sale in Florida
If you are looking for used boilers in Florida, whether for a plant in Tampa, a laundry in Daytona Beach, or a hospital in Miami, it helps to start with equipment that is already in the state. Buying a boiler that sits a few hours away can mean shorter freight and an easy in-person inspection.
Boilers.com buys and sells used commercial and industrial boilers and serves plants nationwide from Miami, Florida. Here are the used industrial steam boilers currently listed for Florida buyers, what Florida’s Boiler Safety Act asks of owners and installers, and what to check before you buy.
Used boilers in stock in Miami, Florida
The first three listings below show Miami as the boiler’s location. Figures come from each listing’s nameplate or listing data. All are call for price. Inventory changes often, so browse all used boilers for sale or call to confirm a unit is still available and where it sits today.
Key specs at a glance
Figures from the listings in this article and from Florida’s Boiler Safety Act. A used boiler’s nameplate is the authority for that specific unit. Confirm location before you plan freight.
2023 Cleaver Brooks CBEX-2D 200-800-150ST, 800 HP
An 800 HP Cleaver Brooks CBEX-2D 200-800-150ST (yard tag BSCB800HP9182), built in 2023 and located in Miami. It is a high pressure firetube steam boiler with a 150 PSI design pressure and a gross output of 26,780,000 Btu/hr. It is dual fuel, natural gas and No. 2 oil, with a gas input range of 4,666,000 to 32,659,000 Btu/hr and an oil input of 33.3 to 233.3 GPH. The nameplate shows a 9 PPM NOx marking.
Gas inlet pressure on the listing is 142.9 to 167.4 inches W.C. at sea level, so check your gas service before you plan an install. This is the largest boiler we have in Florida and a fit for big process steam loads.
1980 Cleaver Brooks CBH 700-60, 60 HP
A 60 HP Cleaver Brooks CBH 700-60 (yard tag BSCB60HP9033), located in Miami, FL. It is a packaged horizontal four-pass dryback firetube steam boiler with an integral burner, 150 PSI maximum pressure, natural gas fired. The listing gives an input of 2,511,000 Btu/hr and a rated capacity of 2,070 lbs/hr from and at 212°F. It has a Honeywell burner control and a 2 HP blower motor, and runs on 480V, 3 phase, 60 Hz power. The listing notes that the published model-family ratings have not been field-tested on this unit.
2012 Columbia CT vertical steam boiler, 50 HP
A 50 HP Columbia Type CT (stock 07052026), located in Miami. It is a vertical tubeless, natural gas fired steam boiler built in 2012 by Columbia Boiler Co. of Pottstown, Pennsylvania, rated 1,725 lbs/hr at 150 PSI maximum allowable working pressure, National Board No. 150807. It has a Power Flame JR50A-15 burner with a 650 to 2,100 MBH input range, a Honeywell burner control, and a water column with low water cutoff probes. It runs on 115V single phase power, and its small footprint suits tight boiler rooms.
2018 Columbia MPH-40 low pressure steam boiler, 40 HP
A 40 HP Columbia MPH-40 (yard tag BSC40HP299). It is a 2018 horizontal three-pass wet-base firetube, natural gas fired at 1,680,000 Btu/hr input with a Power Flame JR30A-13 burner, delivering 1,378 lbs/hr of steam. It is rated 15 PSI steam and 30 PSI water, so it is for heating and low pressure steam, not high pressure process work. It runs on 115V single phase power. Ask us to confirm its current location when you call.
Fulton VMP-130, 130 HP
A 130 HP Fulton VMP-130 (stock W66884), a packaged vertical steam boiler built by Fulton Boiler Works of Pulaski, New York. It is natural gas fired, with a 150 PSI design pressure, a 135 PSI maximum operating pressure, 4,485 lb/hr of steam output, a 5,200,000 Btu/hr maximum input, and 480V, 3 phase power. The listing shows conflicting year and location details, so confirm the date and the location against the nameplate and with us.
Need a different size or brand? Our Ohio, Colorado, Illinois, and New York units can ship to Florida too. See used Cleaver Brooks boilers, used Cleaver Brooks 150 HP boilers, and used Cleaver Brooks 100 HP boilers. On our listings the buyer handles transport and rigging, and we can help arrange shipping or delivery.
Florida boiler rules for buyers of used boilers
Florida regulates boilers under Chapter 554, Florida Statutes, the Boiler Safety Act. The Boiler Safety Section of the Bureau of Fire Prevention, in the Division of State Fire Marshal at the Florida Department of Financial Services, administers it. Here is what matters most when you buy a used boiler for a Florida site.
- Used boilers are allowed. Under section 554.103, the law does not prevent the use, sale, or reinstallation of a boiler if it has been made to conform to the State Boiler Code for existing installations and is found safe on inspection. The statute defines a secondhand boiler as one that has changed ownership and location after its original installation and use.
- Installation permit. The same section says the installer of any boiler placed in use in Florida after January 1, 2018, must apply to the chief boiler inspector for a permit to install, with the boiler’s ASME manufacturer’s data report. The installer must contact the chief boiler inspector to schedule an inspection no later than 7 days before the boiler goes into service. Ask the seller for the ASME data report up front.
- Inspections apply to public assembly locations. Under section 554.108, Florida’s inspection requirements apply only to boilers in public assembly locations. The statute lists schools, day care centers, community centers, churches, theaters, hospitals, nursing and convalescent homes, stadiums, amusement parks, and other locations open to the general public.
- Inspection schedule. At those sites, power boilers (steam above 15 psig) get a certificate inspection every year. Low pressure steam heating boilers and hot water heating and supply boilers get one every two years.
- Certificate of operation. A boiler that passes gets a certificate of operation showing its maximum allowable pressure. It is valid for 12 months for a power boiler and 24 months for a heating or hot water supply boiler, and it must be posted under glass, or similarly protected, in the boiler room. Operating a boiler at a public assembly location without a valid certificate is prohibited.
- Moving a registered boiler. The Boiler Safety Section says that when a boiler is moved or sold to a new facility, the inspecting agency must confirm it was removed from its registered address. If the new location is a place of public assembly, it must be inspected there before the certificate can be changed or renewed.
Rules change, and your site may have local requirements or insurer conditions as well. Check with the Florida Boiler Safety Section and your boiler insurance carrier before you install.
What to check before you buy a used boiler in Florida
A used boiler is only a good deal if it fits your load, your site, and Florida’s rules. Inspect it in person, or have a qualified inspector do it, and match every claim to the nameplate and the records.
FAQ
Do you have used boilers in Florida?
Yes. Right now we list an 800 HP Cleaver Brooks CBEX-2D, a 60 HP Cleaver Brooks CBH 700-60, and a 50 HP Columbia CT in Miami. A 40 HP Columbia MPH-40 and a 130 HP Fulton VMP-130 are also listed; call to confirm availability and location.
Can you deliver a boiler to Tampa, Orlando, or Daytona Beach?
We serve plants nationwide from Miami and can arrange shipping, delivery, or pickup. On our listings the buyer is responsible for transport and rigging, and we can help set it up. Tell us the delivery address when you ask for a quote.
Do I need a Florida permit to install a used boiler?
Section 554.103 of the Florida Statutes requires the installer of any boiler placed in use after January 1, 2018, to apply for a permit to install from the chief boiler inspector, with the ASME manufacturer’s data report. Confirm details for your site with the Florida Boiler Safety Section.
Does my Florida boiler need annual inspections?
If it is in a public assembly location, such as a school, hospital, church, or other site open to the public, yes. Power boilers are inspected every year, and heating and hot water supply boilers every two years. Your insurer may have its own inspection requirements.
Can I rent a boiler in Florida?
Yes. Our boiler rentals page covers emergency, planned outage, and seasonal rentals, with delivery anywhere in the country. Call (305) 428-2777 if your boiler is down.
How do I get pricing?
Our listings are call for price. Call (305) 428-2777 or use our contact page, and tell us the steam load, pressure, fuel, voltage, and timing you need. If you have a boiler to sell in Florida or anywhere else, see we buy boilers.
Find the right used boiler for your Florida site
Start with the units above, or browse all used boilers for sale. For a quote, help with sizing, inspection, or freight, contact us or call (305) 428-2777. We serve Florida and plants nationwide from Miami.
